These energy saving timers use n
Upgrading to an electronic time switch has never been
easier than now with the new ET1100 Series. Features include; Automatic Daylight
Saving Time adjustment, multi-volt operation from 120 to 277 VAC, and
to-the-minute programming for accurate load control and reduced energy costs. Up
to 28 set points or events (14 ON/14 OFF per channel) can be preset to
automatically repeat on a daily basis. The program can be overridden at any
time. Two industrial grade "AAA" alkaline batteries provide 3 years minimum
program and timing protection.
- Model #: ET1115C
- Circuits: 1
- Switch: SPDT
- Clock Voltage: 120/208/240/277
- Amp Rating: 10/30
- HP Rating: 1HP/ 2HP
- Enclosure: NEMA1
Options: Standard: NEMA 1 Grey Painted Drawn Steel; 'R' Option: NEMA 3R Grey
Paited Drawn Steel; 'PD82' Option: NEMA 3R Grey High-Impact UV Resistant
Polycarbonate Plastic with Clear Cover
electronic mechanism snaps into the standard Intermatic time switch case,
replacing mechanical mechanisms, if desired.
Combination 1/2"-3/4" nominal knockouts, one on back and each side of case
and two on bottom.
Voltages and Cycles: ALL models 50 or 60 Hz.
Rating: 30 Amp Inductive/Resistive, 24/ 120/ 240/ 277 VAC 60 Hz; 20 Amp
Resistive, 28 VDC; 1 HP 120 AVC 60 Hz; 2 HP 240 VAC 60 Hz; 5 Amp Tungsten, 120/
240/ VAC 60 Hz; 20 Amp Ballast, 120-277VAC 60 Hz. ET100C same ratings for 120
Volt loads only. ET1115 models normally closed contact ratings: 10A
Resistive/General purpose, 12-277VAC; 10A Resistive/General purpose, 28 VDC; 3A
Ballast, 120-277VAC; 1/4 HP, 120 VAC; 1/2 HP, 240 VAC; 30 LRA; 12 FLA; 275 VA
pilot duty, 120-240 VAC
Feature: 2 Circuit models feature 2-Second pulse option for contactor and
bell ringing applications
Automatic Adjustment for Daylight Saving Time (DST)
Field replaceable "AAA" batteries maintain program and accurate time keeping
for 3 years minimum. Up front replacement does not require removal of mechanism.
Terminals: #18 to #10 AWG wire
ON/OFF Times: 1 minute
ON/OFF Times: 23 hours 59 minutes